Forming of micro-components by electrical-field activated sintering

W1901644653 · 수집 2026-10-04 18:12:17

T12080 Injection Molding Process and Properties

CoT 라벨링

라벨링 전

PDF 파일

저장된 PDF 없음

기본 정보

DOI 제목 발행년도 저널 URL 페이지 열기 PDF URL PDF 열기 발행기관 피인용수 라이선스

추가 정보 초록

Recent research work has been undertaken to investigate the feasibility of forming micro-components by combining Electrical-field activated sintering and micro-forming (Micro-FAST). This paper firstly introduces the Micro-Fast technology and experimental validation method employed. Cylindrical components were used for the experiments and the sintering and forming was realised by use of a Gleeble 3800 thermal-mechanical simulator. Thirteen different types of powders (metallic and ceramic) with variable particle sizes have been formed successfully. The influential parameters, such as pressure, temperature and heating rate, were studied. From the experiment results it is shown that the component quality depends significantly on the pressure, the heating rate and maximum temperature applied. Compared to other sintering technologies, the relatively short forming-cycle time of Micro-Fast (increased heating rate and reduced holding time) makes a good contribution to highly efficient particulate sintering for micro-manufacturing.

본문

PDF 본문 자동 추출 실패: [download] HTTP 403 Forbidden (2026-10-04 20:46:02)

활용가능성

이력 0건

아직 편집 이력이 없습니다. 저장할 때마다 이전 내용이 여기에 백업됩니다.