Bending Moment Capacity of L-Shaped Mitered Frame Joints Constructed of MDF and Particleboard

W1533282595 · 수집 2026-10-04 18:12:13

T10219 Mechanical Behavior of Composites

CoT 라벨링

라벨링 전

PDF 파일

저장된 PDF 없음

기본 정보

DOI 제목 발행년도 저널 URL 페이지 열기 PDF URL 발행기관 피인용수 라이선스

추가 정보 초록

The impact of fastener type (glued and unglued butterfly dovetail keys, glued and unglued H-shaped dovetail keys, one-pin dowel, two-pin dowels, and plywood spline) and wood composite material type on the bending moment capacity of L-shaped mitered frame joints under diagonal tension and compression loads was investigated. Specimens were constructed of laminated medium-density fiberboard (LamMDF) and laminated particleboard (LamPB). The glued joint specimens were constructed with polyvinyl acetate (PVAc) adhesive. In both tests, joints reinforced with two dowels had the highest bending moment capacity, whereas unglued joints fastened with H-shaped dovetail keys had the lowest capacity. Splined joints were characterized by the second highest bending moment capacity. Two-pin dowel joints had, on average, 47% greater capacity than one-pin dowel joints. The glued dovetail joints were 31% stronger than the unglued joints. There was no statistically significant difference between the bending moment capacities of butterfly and H-shaped dovetail keys. The LamMDF joints exhibited 7.8% greater capacity than joints constructed of LamPB. Overall, the bending moment capacity of joints loaded in compression was 22% higher than that of joints loaded in tension—when the moment arm in the compression specimens was taken at the inside corner of the joint.

본문 활용가능성

이력 0건

아직 편집 이력이 없습니다. 저장할 때마다 이전 내용이 여기에 백업됩니다.